# 4 

Place both rear quarter panels and rear filler on ground as it will be installed on vehicle.  Line up rear quarter panels against rear filler so they align properly.  Drill a 1/4” hole from rear filler through rear quarter on top and bottom, repeat for other side.

Place 2” masking tape on back lower end of bumper for rear quarter hole placement.  Hold rear quarter in mounting position and trace quarter with felt pen onto masking tape for insert hole placement.  Place end of rear quarter on cardboard and trace again for template.  Cut template out so that an impression of insert is left in template.  With screwdriver, push through impression for insert hole marking.  Place template inside marking on masking tape and mark for drilling.  Drill 3/8” hole through marking, (large enough so insert head goes through mounting hole).  Place rear quarter in mounting position and install 1/4 x 20 x 1/2” bolt, small washer, thin large washer, and thick large washers from back side.  Move to rear wheel well, press in on rear quarter, drill and install 1/2” sheet metal screw with smallest washer.  Please note that rear quarter mounts up in wheel well only 1/2” to 3/4” from bottom. Repeat on opposite side.

To install rear filler piece, place filler under bumper and attach upper and lower 3/4” sheet metal screw, smallest washer, and black tinnerman nut on opposite side (these holes should already be drilled from step one in instructions).  Once filler is attached to rear quarter drill through filler tab, (2 holes each small tab, 3 in center tab), and install 1/4” x 3/4” sheet metal screw and washer.

NOTE:  If exhaust pipe is covered by rear wrap, (sides or back), you can cut out rear quarters, or filler, or get an extension so your exhaust pipe will hang lower, (these can be obtained at any muffler shop).  For Monte Carlo SS we suggest you cut exhaust tips back far enough to install exhaust tip turn downs.  They look good and work great.