#6
Installation Instructions for
LEX-18-EL Designer Air Delfector
* Note: Your vehicle must have the factory front spoiler for this
application.
We have made the installation of this air deflector as easy as
possible yet we do advise you rear the entire instructions
CAREFULLY. Take your time and use some craftsmanship. The end
results with be worth the effort!
Tools Needed:
Drill & drill bit set
Phillips Screwdriver
Center your air deflector on the center of S/S front spoiler,
making sure your air deflector is even,
Drill hole in center, and secure firmly with 1/4” x 3/4” sheet
metal screws, washers and black Tinnerman nuts on the backside,
while working your way out.
* Note: When drilling near vents in S/S front spoiler use caution
not to drill through vents.
When reaching curves, be sure to tighten screws before working your
way around.
When fastening around curve, push in with thumb, to get required
alignment of air deflector.
Drill hole and tighten screws before continuing.
The end pieces should be lined up with end of the air deflector.
Drill and fasten.
