Lauren Engineering
 
(714) 871-CARS

Home
New Products
About Us
Basic Knowledge
El Camino
 Monte Carlo
Hust Olds
Grand National
Malibu
Grand Prix
 How to Order
Installing Parts
How to Install
#1
#2
#3
#4
#5
#6
#7
#8
#9
#10
#11
#12
#13
#14
#15
#16
#17
#18
#19
#20
#21
#22
#23
#24
#25
#26
#27
#28
#29
#30
#31
#32
#33
#34
#35
#36
#37
#38
#39
#40
#41
#42
#43
#44
#45
#46
#47
#48
Videos
Order Form
Shipping Chart

PLEASE NOTE THAT THIS PAGE WILL TAKE ALONG TIME TO LOAD PLEASE BE PATIENT
IF YOU WOULD LIKE TO PRINT JUST THE ARTICLES BELOW:
Click on the right side of your mouse on top of the article, a little window will pop up click on "SAVE PICTURE AS" Save the image to  your computer. Then open the file and print the articles. (Please repeat for the other article)

#26 

Wiring Instructions for 3rd Brake Light.


We have made the installation of this part as easy as possible yet we  advise you read the entire instructions CAREFULLY.  Take your time and use some craftsmanship.  The end results will be worth the effort!

The black wire is the ground and should be connected to the chassis.  The black and white striped wire is connected to the constant brake of your wiring harness.  Use wire connectors to join the two.

On El Camino 3rd brake lights, you must be able to disconnect wiring from harness when removing bed cover.  Do this by installing wire disconnectors included in your installation package.

With all 3rd brake lights be sure to route your wiring so it is out of the way of any obstructions.  Do this by holding wires up into place and placing silicone over wires and then a piece of tape over silicone and wires until dry.