#30 

We have made the installation of your Front Bumper Cover as simple as possible, yet we advise that you read the entire instructions CAREFULLY.  Take your time and apply some craftsmanship.  The end results will be worth the effort!

Place both bumper cover and fender extensions on the ground as they will be installed on the vehicle.  Line up front extensions with cover so they align properly.  Drill four 1/4” holes, (evenly top to bottom), from fender extension to cover both sides.  Secure with 3/4” hex bolts, washers, and hex nuts.

Remove front bumper, (4 bolts per bumper shock).  Disconnect turn signals and remove from chrome bumper.  Remove both rubber fillers attached to sides and top of fender and header panel, (save the nuts as they will be used to install bumper cover).  Remove chrome cosmetic cover from header panel.  Disassemble chrome bumper from inner bumper keeping cosmetic panel located in top of inner bumper and reinstall inner bumper to vehicle, loosely.  Reinstall turn signals to cover.

Drill marked holes in sides of bumper cover, large enough for adjustment when installed to front fender.  Install cover to vehicle by lifting from front bottom of cover leaving fender extension angled toward the ground, so extensions will slide up into wheel wells.  Secure cover with hex nuts that were used to secure rubber fillers.  Install two 10/24 hex bolts and lock nuts to secure cover to header panel at grill opening.  Note:  additional attachments can be made from header panel (in front of headlights)to cover, if need be.

With fender extension inside wheel well, drill and install a 3/4” sheet metal screw.  Pull slightly out at bottom center of extension and install final 3/4” sheet metal screw.

To install intercooler extension to cover, simply attach with two 3/4” hex nuts, washers, and hex bolts per flange. Attach extension to intercooler by installing three 3/4” sheet metal screws, washers, and black Tinnerman nuts from extension to intercooler.