#43 

Tools Needed: Drill and Drill Bit Set    Phillips Screw Driver     7/16” Wrench

We have made the installation of this front spoiler as easy as possible, yet we  advise you read the entire instructions CAREFULLY.  Take your time and use some craftsmanship.  The end results will be worth the effort!

We also recommend that you install your front spoiler before painting, in case trimming is needed.  It is easier to install freshly painted front spoiler if the holes are already predrilled.

Place front spoiler on the ground as it would be installed on vehicle.  Position sides with center so that the paintable side is out.  Line up sides with center and drill  top and bottom holes through (A) inner tabs with 1/4” drill bit.  Install two 10 x 24 machine screws with washers and nuts.  Repeat for opposite side and disassemble. Some filing may be needed so sides and center fit properly.

Drill and install the steel U-bracket to the bottom center of the fender (B). This will give you the mounting point to install the J-trim (C). The side must fit tightly up into the J-trim. The bottom steel U-Bracket will hold the side in place, so press down hard on the J-trim and mark the location for the J-Trim installation. Once the J-Trim is installed, place the side panel up into it and attach U-Bracket to the bottom of the fender. The side panel must fit tightly with no up or down play. Next, drill and place two sheet metal screws with washers in the front wheel well opening (F).
Place black J-Trim in the sun, or heat it up with a hair drier, so it will be easier to work with.  When heated,  place J-Trim on top of spoiler side, (longer side against vehicle).  Push side tightly against fender and push up into J-Trim. You can use up to 5 sheet metal screws per side (D).  

Start from center spoiler and work out.  Place L- Brackets up against the bottom of the inner bumper. Drill and attach with two washers and sheet metal screws.  Be sure that L- Bracket is pulled out against one of the five center top tabs before drilling into bottom of bumper.  Next, drill through to center spoiler tab and lower L- Bracket.  Attach with 1/4 x 20 x 1” hex bolts and nuts.